Fly Epoxy Grout

A high-performance, two-component grout based on epoxy resins and special fillers. It provides a smooth, durable, and stain-resistant joint with excellent chemical resistance and low water absorption. Ideal for areas requiring superior hygiene, strength, and long-lasting aesthetics such as kitchens, swimming pools, laboratories, and commercial spaces

Tiles Adhesive and Grout Products

Fly Epoxy Grout

Fly Epoxy Grout EN 13888 RG

Description

Taneem Tiles adhesive is a cement-based tile
adhesive. It provides high initial and final
adhesive strength and moisture resistance.

Advantages:

– Special for ceramic
– Water resistance
– suitable for internal and external
– Self-cured
– Require only addition water on site
– Suitable for horizontal and vertical
application
– Not suitable for smooth surface and
non-absorbent tiles

Certified according to BS EN 12004 section C1 adhesive

Fields of application

Taneem Tiles adhesive is suitable for fixing absorbent wall or floor tiles on a rough surfaces and especially where high adhesion and resistance to moisture are required. Suitable for indoor or outdoor use.

Technical data

Cementitious mortar
White and gray
7.25:7.75 l / 25Kg bag
Up to 10 mm
At least 20 min
≥ 0.5 N/mm²
≤ 0.5 mm

Direction for use

1. Substrate The surface to be overlaid must be clean, free of dust, grease, paint, loose materials, etc. Dampening of the substrate before application is recommended.
2. Application Taneem tiles adhesive is gradually added to water under continuous stirring, until a uniform paste is formed. A low-speed mixer is recommended for mixing. The mixture should be left to stand for about 5 minutes and then stirred again. The tile adhesive should be uniformly applied (“combed”) over the entire surface using a notched trowel. The tiles should be firmly pressed to the desired position. The applied mixture must be covered with tiles within 20 minutes to avoid “skin” formation, i.e. before the adhesive film starts to set.

Elastification

When tiling on unstable substrates, such as gypsum boards, chipboards, heated floors, flat roofs, terraces, balconies, etc., where high flexibility or adhesion is required to accommodate movement caused by vibration or expansion and contraction, it is necessary to add up to 3.75 kg of Fly SBR Bond to 25 kg of Taneem tiles adhesive, plus a certain amount of water depending on the desired workability.