Fly 101
Fly 101
Rough powders dissolve easily in water before application. Give a rough, hard, and paintable surface. Ideal for use in patching and leveling fair-faced concrete.High-quality cement-based product modified with special polymers and micro-fibers, ready mixed one-component for leveling internal and external surfaces before coating application
Repair Mortar
Fly 101
Fly 101 Multi-Purpose Patching and repair Mortar
Rough powders dissolve easily in water before application. Give a rough, hard, and paintable surface. Ideal for use in patching and leveling fair-faced concrete.High-quality cement-based product modified with special polymers and micro-fibers, ready mixed one-component for leveling internal and external surfaces before coating application
Description
Taneem Tiles adhesive is a cement-based tile
adhesive. It provides high initial and final
adhesive strength and moisture resistance.
Advantages:
– Special for ceramic
– Water resistance
– suitable for internal and external
– Self-cured
– Require only addition water on site
– Suitable for horizontal and vertical
application
– Not suitable for smooth surface and
non-absorbent tiles
Certified according to BS EN 12004 section
C1 adhesive
Fields of application
Taneem Tiles adhesive is suitable for fixing
absorbent wall or floor tiles on a rough
surfaces and especially where high adhesion
and resistance to moisture are required.
Suitable for indoor or outdoor use.
Technical data
- Base
- Color
- Water demand
- Application thickness
- Open time
- Tensile strength 28 day
- Slip
- Cementitious mortar
- White and gray
- 7.25:7.75 l / 25Kg bag
- Up to 10 mm
- At least 20 min
- ≥ 0.5 N/mm²
- ≤ 0.5 mm
Direction for use
1. Substrate The surface to be overlaid must
be clean, free of dust, grease, paint, loose
materials, etc. Dampening of the substrate
before application is recommended.
2. Application
Taneem tiles adhesive is gradually added to
water under continuous stirring, until a
uniform paste is formed. A low-speed mixer is
recommended for mixing. The mixture should
be left to stand for about 5 minutes and then
stirred again. The tile adhesive should be
uniformly applied (“combed”) over the entire
surface using a notched trowel. The tiles
should be firmly pressed to the desired
position. The applied mixture must be covered
with tiles within 20 minutes to avoid “skin”
formation, i.e. before the adhesive film starts
to set.
Elastification
When tiling on unstable substrates, such as
gypsum boards, chipboards, heated floors, flat
roofs, terraces, balconies, etc., where high
flexibility or adhesion is required to
accommodate movement caused by vibration
or expansion and contraction, it is necessary
to add up to 3.75 kg of Fly SBR Bond to 25 kg
of Taneem tiles adhesive, plus a certain
amount of water depending on the desired
workability.