Taneem Mortar F

Taneem Mortar F

Rough powders dissolve easily in water before application. Give a rough, hard, and paintable surface. Ideal for use in patching and leveling fair-faced concrete. High-quality cement-based product modified with special polymers and polypropylene fiber, ready mixed one-component for leveling internal and external surfaces before coating application. Contain ordinary Portland cement conforming to ASTM C 150 (450 KG/M³ Sand) and sand free of salts and well graded

Repair Mortar

Taneem Mortar F

Taneem Mortar F
Taneem Mortar F
Multi-Purpose ready mixed mortar reinforced by fiber
Rough powders dissolve easily in water before application. Give a rough, hard, and paintable surface. Ideal for use in patching and leveling fair-faced concrete. High-quality cement-based product modified with special polymers and polypropylene fiber, ready mixed one-component for leveling internal and external surfaces before coating application. Contain ordinary Portland cement conforming to ASTM C 150 (450 KG/M³ Sand) and sand free of salts and well graded
Data Sheet
Description

Taneem Tiles adhesive is a cement-based tile
adhesive. It provides high initial and final
adhesive strength and moisture resistance.

Advantages:

– Special for ceramic
– Water resistance
– suitable for internal and external
– Self-cured
– Require only addition water on site
– Suitable for horizontal and vertical
application
– Not suitable for smooth surface and
non-absorbent tiles

Certified according to BS EN 12004 section C1 adhesive
Fields of application
Taneem Tiles adhesive is suitable for fixing absorbent wall or floor tiles on a rough surfaces and especially where high adhesion and resistance to moisture are required. Suitable for indoor or outdoor use.
Technical data
  • Base
  • Color
  • Water demand
  • Application thickness
  • Open time
  • Tensile strength 28 day
  • Slip
  • Cementitious mortar
  • White and gray
  • 7.25:7.75 l / 25Kg bag
  • Up to 10 mm
  • At least 20 min
  • ≥ 0.5 N/mm²
  • ≤ 0.5 mm
Data Sheet
Certifications
Direction for use
1. Substrate The surface to be overlaid must be clean, free of dust, grease, paint, loose materials, etc. Dampening of the substrate before application is recommended.
2. Application Taneem tiles adhesive is gradually added to water under continuous stirring, until a uniform paste is formed. A low-speed mixer is recommended for mixing. The mixture should be left to stand for about 5 minutes and then stirred again. The tile adhesive should be uniformly applied (“combed”) over the entire surface using a notched trowel. The tiles should be firmly pressed to the desired position. The applied mixture must be covered with tiles within 20 minutes to avoid “skin” formation, i.e. before the adhesive film starts to set.
Elastification
When tiling on unstable substrates, such as gypsum boards, chipboards, heated floors, flat roofs, terraces, balconies, etc., where high flexibility or adhesion is required to accommodate movement caused by vibration or expansion and contraction, it is necessary to add up to 3.75 kg of Fly SBR Bond to 25 kg of Taneem tiles adhesive, plus a certain amount of water depending on the desired workability.
Contact Us
Contact Us
Scroll to Top